fbpx

Step by Step Guide

Step by Step Guide

  1. Remove any mascara & eye make-up with Bioderma solution.
  2. Apply UNDER EYE PADS TO LOWER EYE and fasten lower lashes to eye pad to protect during perming process.
  3. Ask client to close their eyes and apply lash mould tightly along the lash line from the corner of the tear duct to the outer edge of the eye.
  4. Once correct mould length is selected apply lash glue onto the lash mould and gently adhere onto the eyelid.
  5. To ensure we get an even and balanced lash line, push the lash mould tightly along the lash line to ensure there is no gap between the lashes or mould. Hold down until the mould is securely adhered onto the eyelid with no visible lift.
  6. Apply lash glue ono the lash mould and comb lashes directly upwards with lash tool so that each individual lash strand is perfectly set in a neat and even upward direction. (If there is any lash over lap or unevenness, apply a little more lash glue on the area to liquify glue and brush lash up until lashes are in a desirable position. This part is extremely important as it affects our end result. This will determine whether our lash lift appears neat or messy).
  7. Apply the perming solution over the entire lash from roots to ends with a micro-tip. Remove any excess perming solution off skin and cover with cling film for up to 10 minutes. (For finer hair let solution develop upto 5 minutes to avoid over processing)
  8. Remove all setting solution with a clean cotton tip & apply the setting solution over the lash hair. Cover with cling film and let it set for  5-10 minutes.
  9. Remove setting solution and apply desired lash tint. This should process for 15minutes.
  10. Tilt head to the side place petri dish on the side of the face and Remove excess lash tint with a clean cotton tip and clean entire lash mould with a damp cotton pad (tepid water) until all the lash tint and gel is removed and cotton pad is clear of any transfer. If the mould is still adhered to the skin apply a wet cotton tip in between the mould and skin and gently etch away until you get some lift. For any stubborn glue we can apply some nourishing oil to remove any excess glue.
  11. Brush through lashes with spoolie and apply nourishing oil.
  12. Clients must avoid wetting their lashes for 24hrs after procedure.